They have support guides in both tandem mounting kits. The differences in heights for each job, the customer is required to take care of the actual support rods and lock nuts. They need to be put onto the same mounting area as the pump and motor. Needs to be aligned to .003″ to …
If you have questions about this Parker unit or any Parker models, we can help with repairs or get you a brand new one. Call us today for a Quote ….662-871-8403 tupelohydraulics@gmail.com
The changes are being made to the 55cc, 75cc and 100cc variable displacement pumps/motors. The old part kit had a spacer, slipper, guide bearing for the slipper and slipper retainer. The spacer give it a certain amount of clearance for the slipper and slipper retainer. The guide bearing helps with the wear area for the …
They put in an extra procedure to the spline part of the block. These three groove identification measures will be put on there to let you know you have a new model. Other measurements on the block want change. The pumps want change, but your service kits for the block will have this procedure on …
They are making changes to the 55cc, 75cc and 100cc fixed displacement motor and 55cc/75cc variable displacement motors. Right now it has an indented seat in the endcap. It gave it a more wearable area for the charge pressure relief valve poppet. Now it has been machined to sit right into the surface that it …
Sundstrand Series 90/100cc – Charge Relief Seat Change Read More »
To assemble this put the retaining ring and check valve balls in the holes of the pintle. Push a new check valve into the holes and push it hard enough it goes past the coil pin allowance. And don’t push so hard you make the retaining rings you make the check valves come out …