Look on the model code for control data information each model. C and CM Pressure Compensators This means it will intuitively change how the pump will handle pressure at a predetermined time and amount of pressure at the time it is needed. The amount of pressure can go up or down (60 – 90 psi) […]
Vickers PVB/PVB5/PVB10/PVB6/PVB15/PVB29 Control Data Read More »
Call us for any of your Dynapower Cube 9 or Goldcup needs at 662-871-8403 or 800-361-0068 sales@tupelohydraulics.com sales@htsrepair.com
Dynapower Cube 9 Generation ll Part 1 Read More »
This is a breakdown of this unit. If we can help with parts or repair of this unit, call us for a quote today. We also can repair or sell you a new one on any style or model of Denison units. And we buy surplus parts also. Just email us with what
DENISON HYDRAULICSM4D – M4SD – M4D1 – M4SD1 Vane Motor Read More »
If you need more info on this type of unit, call us at 662-871-8403 or 800-361-0068 sales@tupelohydraulics.com
Rexroth DRF (DFR) and DRS (DFR1) – Pressure and flow control Read More »
General Information of this pump This tells what each item is on this pump. Will help in ordering parts . If you need further assistance, call us at 662-871-8403 sales@tupelohydraulics.com
PARKER/DENISON HYDRAULIC T6DCC – T6DCC Hydraulic Pump Read More »
The tag on your hydraulic/hydrostatic pump or motor tells alot of information needed to help fix your unit,for parts or get a new unit all together. When that tag is torn off or worn off, makes it hard to identify your unit so you can get the correct unit or parts that fit your specific
Sundstrand Sauer Danfoss – Meanings of The Numbers On A Tag For A Pump/Motor Read More »
Drive shaft and bearing need to be cleaned thoroughly and put a coating of oil on them to help with wear and tear on the parts. To put the drive shaft back together start with a retaining ring going over the internal end of the shaft and put in the groove that is closest to
If you have any other questions, call us at 662-871-8403 or 800-361-0068 sales@tupelohydraulics.com
Racine Pump Controls SV 51 thru 63 Series Read More »
The units that are affected by this are the 42cc, 55cc, 75cc and 100cc. On your older design the spring and the spring seat were set apart on the motor. The new way is designed has two parts that go into a one part assy. And it will make putting it together a whole lot
Sundstrand Series 90-75cc Motor – Loop Flushing Spring & Seat Read More »
On the new models the MDC, the trepan groove has been taken out from the two servo ports on the control. So now you will need washers put into the two servo ports. The washers are put in all the kits now. You will need to put the orings in the servo port outlets. Put
Sundstrand Series 20 Manual Displacement Control Read More »